Campbell CR23X Manual de usuario descargar pdf (Pagina 7)

“Sensors” button in the window of Fig. 5 and the “home” button in the window of Fig. 3.

You should be back now to the main menu (Fig. 1).

5. Press the “Output” button on in the main menu and a window like Fig. 6 will appear. This

window allows you to choose the output preferences in your data file once data collection

begins. First, under “Selected Sensors”, choose those sensors you wish to include in the

output data file. Click on your thermocouple sensor (should be highlighted in blue) and

place it into the “Selected Outputs” window by choosing Average, Minimum or

Maximum (or you may choose all three, in desired). Now, your window should read as

Fig. 7. Under then “Selected Outputs” window, choose the “Data Storage” interval in

minutes or seconds. A sampling interval of 1 minute is sufficient for short tests, unless

you will be exposing the temperature sensor to a rapid temperature change. This is an

important step which determines the total number of sampling points saved to your

output file. Click the Home button to return to the Main Menu.

Fig. 6 Definition of the output with selected sensor.

6. Now it is time to finish the program you have just written in SCWin. On the Main Menu

choose, “Finish”. This will tell SCWin to write the program and save it to the indicated

file. Click “Ok” (see Figure 8).

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Sin comentarios

Campbell CR23X Manual de usuario Pagina 7