Campbell CR23X Manual de usuario descargar pdf (Pagina 13)

Fig. 11 Setting Range of Sensor Voltage

The wiring diagram labeled “Full Bridge” represents the pressure transducer. The

pressure transducer has four prongs. On the bottom of the transducer these prongs are

numbered, note that the numerals are very small. Prong one will connect to the “Excite”

wire which is then connected to port E1 of the data logger. Prong two will connect to the

“High” wire which is then connected to port 1H. Prong 3 is connected to the “Ground”

wire which is then connected to port AG. Prong 4 is connected to the “Low” wire which

is then connected to port 1L. “Shield” is the bare wire in the cable bundle and is

connected to port G. It is set up so that:

Prong 1—Red Wire—Port E1

Prong 2—White Wire—Port 1H

Prong 3—Black Wire—Port AG

Prong 4—Green Wire—Port 1L

Press the “Sensors” button in the window of Fig. 12 and the “home” button in the

window of Fig. 10. You should be back now to the main menu (Fig. 1).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Sin comentarios

Campbell CR23X Manual de usuario Pagina 13