Campbell CR23X Manual de usuario descargar pdf (Pagina 15)

6. Now it is time to finish the program you have just written in SCWin. On the Main Menu

choose, “Finish”. This will tell SCWin to write the program and save it to the indicated

file. Click “Ok”. Again this will look similar to Figure 8.

Connect Computer and Transfer Program

This is done the same as an Example 1. Follow steps seven, eight, and nine of Example 1. Be

sure to select the correct program at step nine.

Monitor data collection

Click “Monitor Location”. A screen similar to figure 14 should appear. Battery voltage,

temperature relative to 20

C, and output from the transducer is shown. Note that the transducer

output is given in millevolts. The pressure transducer must be calibrated so that these voltages

can be converted to pressure.

Fig. 14 Monitoring Pressure and Temperature

Collect and Post Process Data

Collect data and post process data in the same manner as Example 1 following steps ten, eleven,

and twelve.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Sin comentarios

Campbell CR23X Manual de usuario Pagina 15