Campbell CR23X Manual de usuario descargar pdf (Pagina 10)

10. Now, you must load the program you just created in SCWin to PC200W. Locate your

program under “Associated Program” under the “Program” portion of the window.

Navigate to the proper directory and choose the .DLD file you created. Click “Open” and

“Send” your program to the CR10X from your computer terminal. Click “Set Now” to

synchronize your data logger with the clock on your computer.

Monitor Data Collection & Collect Data

Now it is time to see if your data logger is receiving sufficient power and communicating

with the sensors to receive measurements from the sensors. Click on “Monitor Locations”

in the upper left hand corner of the PC200W window. Select the readings to be viewed

with two decimals (0.00) and for the values to be updated once every second. In the

Value Field viewer, you will see the

battery voltage, program signal and your

thermalcouple temperature (relative to

C). Now click “data Collection”. Your

screen should appear is in Fig. X. Click on

“Collect to” to determine the location of

your data file. Name your file and click

“Save”. Tell PC200W “What to Collect”

by clicking “New Data from Datalogger”.

Click “Collect” and then click “Ok” on the

“Information Window” after the data

collection process is complete. (If the data

collection process does not complete,

return to Step 7.).

Monitor Locations

Load Program

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Sin comentarios

Campbell CR23X Manual de usuario Pagina 10