Campbell CR23X Manual de usuario descargar pdf (Pagina 23)

11. Click Enable/Disable Channels… a menu similar to Figure 3 should appear.

Check Channel 1 and uncheck any other channels that may be active. Use the

drop down menu to choose the correct device that you plugged into the channel.

For this case it should be “+32 F to +110 F [TMCx-HB}”. Click Apply. This

should return you to the previous page which should now be updated, similar to

Fig. 2

Fig. 3 Enabling Channels

12. Now click Start in the upper right hand corner of the screen. A warning will

appear. Answer Yes to continue. The program will then launch the HOBO.

Another pop-up will appear. Unplug the serial cable connecting the HOBO to the

computer, then click OK. The HOBO should now be collecting data. The red led

light should blink as the HOBO takes measurements. The BoxCar window on the

computer will have no new information or active buttons.

Reading Data

13. To view the data that has been collected you need to reconnect the serial cable to

link the HOBO and computer. Start from the same screen as you did to launch

the HOBO, Fig. 1. This should also be the same screen you were left at after you

finished launching the HOBO at the end of step 12. Again click Logger, but

now choose Readout. The HOBO and computer will connect and a warning will

pop up, fig 4. Unplug the serial cable connecting the HOBO and computer, then

click OK.

Fig. 4 Warning Pop-Up

1 2 ... 18 19 20 21 22 23 24 25 26

Sin comentarios

Campbell CR23X Manual de usuario Pagina 23