Campbell RF410 Manual de instrucciones Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 124
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
PakBus Networking Guide
14
i. Highlight CR205_3 and change PakBus Address to 3.
FIGURE 9. CR205_3 Setup
Step 11 – Set up Network Hardware
a. Verify the following:
9 Antennas are on RF400s and CR205s.
9 12V supply is connected to base RF400
9 Base RF400’s RS-232 port is attached by SC12 cable to PC COM
port
b. Cable the ‘router’ RF400’s CSI/O port to the CR10XPB.
c. Place CR10XPB/RF400 and CR205s within range of each other.
PC
RF400
(base)
RF400
(remote)
CR10XPB_1
(router)
CR205_2
CR205_3
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 123 124

Comentarios a estos manuales

Sin comentarios