Campbell RF410 Manual de instrucciones descargar pdf (Pagina 10)

PakBus Networking Guide

FIGURE 1. PakCom I/O Terminal Screen

• Click on I/O Terminal, click on Open Port, and press the RF400’s

“Program” green button.

• Press “3” to Restore Defaults.

You have just selected (among other things) the default Hopping

Sequence of “0”. It is best to have an ‘unused’ Hopping

Sequence. You can determine if other RF400s near your location

are using a Hopping Sequence by powering down all but one

RF400 (with antenna) and watching for activity in the green LED

over a period of time (close LoggerNet for this test). Other

available Hopping Sequences are 1 to 6. If you select another

Hopping Sequence, set all network radios to the same setting.

• Configure Standby Mode to “< 24 mA always on”

• Leave other settings at defaults (including the Net Address and Radio

Address and leave the Active Interface in “AutoSense” mode).

• Save All Parameters and Exit Setup.

Step 2 – Set up Remote RF400 Series

a. Label the other RF400 “remote”.

b. Restore Default settings.

c. Verify that remote RF400 is set up for the same Hopping Sequence, Net

Address, and Radio Address as the base RF400.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 123 124

Sin comentarios

Campbell RF410 Manual de instrucciones Pagina 10