Campbell CR510 Manual del operador descargar pdf (Pagina 218)

TD ADDENDUM  SECTION 1. FUNCTIONAL MODES

AD-1-4

to which memory is cleared on powerup, to set

the PakBus ID, and to set communication to full

or half duplex.

CSI datalogger support software makes use of the

∗D Mode to upload and dow

nload programs from a

computer. Appendix C gives some additional

information on Commands 1 and 2 that are used

for these operations.

When "∗D

" is keyed in, the CR10X will display

"13:00". A command (Table 1.8-1) is entered

by keying the command number and "A".

TABLE 1.8-1. ∗D M

ode Commands

Command Description

1 Send (Print) ASCII Program

2 Load ASCII Program, ∗0 Compile

2-- Load ASCII Program, ∗6 Compile

3 # Rings Before Answering Phone

7 Erase Current Program

10 Set Powerup Options

12 Set Initial Baud

15 PakBus Address/Routing Table

16 Memory for General Purpose File

17 PakBus Routing Table

18 PakBus Beacon Interval

19 PakBus Neighbor List

If the CR10X program has not been compiled

when the command to save a program is entered,

it will be compiled before the program is saved.

When a program is loaded, it is immediately

compiled and run. When a command is complete,

"13:0000" is displayed; ∗D must be entered again

before another command can be given.

TABLE 1.8-2. Program Load Error Codes

E 94 Program Storage Area full

E 95 Program does not exist in flash

E 96 Storage Module not connected or

w

rong address

E 97 Data not encountered within 30 sec.

E 98 Uncorrectable errors detected

E 99 Wrong type of file or Editor Error

1.8.1 ERASING CURRENT PROGRAM

The 7 command may be used to delete the

c

urrent program as show in Table 1.8-3.

TABLE 1.8-3 Deleting Current Datalogger

Program

Key entry Display

∗D

13:00

7A 07:00

You may now enter:

0A Erase active program (i.e., load a

blank

program; memory allocation

and Final Storage are reset).

1.8.2 PROGRAM TRANSFER WITH STORAGE

MODULE

Not supported in Table Data Operating

S

ystems.

1.8.3 FULL/HALF DUPLEX

Not supported in Table Data Operating

S

ystems.

1.8.4 SET DATALOGGER ID

Command 8 not supported in Table Data

O

perating Systems.

1.8.5 SETTING POWERUP OPTIONS

Setting options for the Program on Powerup

allow

s the user to specify what information to

retain from when the datalogger was last on.

This allows Flag/Port status, the User Timer,

and the Input/Intermediate Storage to be

cleared or not cleared.

Table 1.8-8. Setting Powerup Options

Key entry Display

∗D

13:00

10A 10:0X

Where X is the powerup option currently

s

elected. You may now change the option:

0A Clears input locations, ports, flags, user

tim

er, and intermediate storage locations.

1A Clears intermediate storage only (leaves

Input Stor

age, Flags/Ports, and User Timer

as is).

2A Doesn’t clear anything.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 263 264

Comentarios a estos manuales

Sin comentarios