Campbell CS300 Manual de usuario descargar pdf

CS300

Apogee Silicon Pyranometer

 e CS300 uses a silicon photovoltaic detector mount-

ed in a cosine-corrected head to provide solar radia-

tion measurements for solar, agricultural, meteorologi-

cal, and hydrological applications. Calibrated against

a Kipp & Zonen CM21 thermopile pyranometer, the

CS300 accurately measures sun plus sky radiation for

the spectral range of 300 to 1100 nm. Sensors cali-

brated to this spectral range should not be used under

vegetation or arti cial lights.

 e standard output is 0.2 mV per W m

-2

, which pro-

vides a signal of 200 mV in full sunlight (1000 W m

-2

All of our dataloggers, including the CR200-series, can

measure this output.

Construction

 e dome-shaped head prevents water from accu-

mulating on the sensor head. To eliminate internal

condensation, the sensor head is potted solid and the

cable is shielded with a rugged Santoprene casing.

Sensor Mounts

Accurate measurements require the sensor to be

leveled using a 18356 leveling  xture.  is leveling

 xture incorporates a bubble level and three adjusting

screws.  e 18356 mounts to a tripod or tower using

the CM225 mounting stand. For most applications,

Campbell Scienti c recommends attaching the CM225

to a CM202, CM204, or CM206 crossarm.  e CM225

can also be attached to a tripod or tower mast.

Ordering Information

Silicon Pyranometer

CS300-L Silicon Pyranometer with user specified cable length;

enter the cable length after the L. An 11-ft length

(CS300-L11) is recommended for a 3-m mounting height.

Must choose a cable termination option (see below).

Cable Termination Options (choose one)

-PT Cable terminates in stripped and tinned leads for direct

connection to a datalogger’s terminals.

-PW Cable terminates in connector for attachment to a

prewired enclosure.

Accessories

18356 Base and leveling  xture required to level the sensor.

CM225 Mount for attaching to the 18356 and sensor to a tripod,

tower, or vertical pipe.

The typical con guration for attaching the CS300 to a tripod or

tower is shown above.

CS300

18356 Base and

Leveling Fixture

CM225 Mount

Crossarm attaches

to tripod or tower

The 18356 levels the sensor in the horizontal plane, helping to

ensure accurate solar radiation measurements.

Bubble level

Adjusting screw

1 2

Indice de contenidos

Pagina 1 - Apogee Silicon Pyranometer

CS300Apogee Silicon Pyranometer e CS300 uses a silicon photovoltaic detector mount-ed in a cosine-corrected head to provide solar radia-tion measure

Pagina 2 - Wavelength (nm)

Mas documentos para De medición, control y control Campbell CS300

a Ver el documento Campbell CS300 Manual de instrucciones

Campbell CS300 Manual de instrucciones (28 paginas)

a Ver el documento Campbell CS300 Manual de usuario

Campbell CS300 Manual de usuario (2 paginas)

Comentarios a estos manuales

Sin comentarios

Campbell CS300 Manual de usuario

Busca en linea o descarga Manual de usuario para De medición, control y control Campbell CS300. CS300 Apogee Silicon Pyranometer Brochure Manual de usuario

Indice de contenidos

Mas documentos para De medición, control y control Campbell CS300

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Campbell CS300