Campbell PC208W Manual de usuario descargar pdf (Pagina 12)

MicroMet Manual Pg. 9

T – Test transmission. MicroMet will turn on its transmitter and attempt to send

whatever is in its immediate transmit queue. This is a quick way to test the antenna

system. Any faults will result in warning messages. If no warnings are displayed, then

the antenna and transmitter systems are OK.

Warning: Test transmission is meaningless until a data message has been

enqueued. After a COLDSTART, set the time and use canmsg to enqueue a data

message before using Test transmission.

Version 1.05 and above will generate a single canned message if no message has been

enqueued.

Time [YY MM DD HHMM] – Display or set the unit’s real time clock.

Verbose [+] or [-] or [nn] – Display or set the level of advisories issued by MicroMet.

Any value between 1 and 100 may be entered. + increments the value by one, -

decrements the value by one. The default value is 1. A value of 5 or above will allow

MicroMet to display data reports as they are received from the CR10X (see Warnings

and Advisories, pg 10.)

Txrate [n] – Display or set the sync rate at which MicroMet is allowed to respond to

AMBCS. MicroMet will respond to no more than every nth sync. This keeps remotes in

close proximity to each other from responding simultaneously. Default is 10.

Warning: Please check with the AMBCS system administrator before adjusting this

parameter!

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Sin comentarios

Campbell PC208W Manual de usuario Pagina 12