Campbell CVF4 Manual de instrucciones descargar pdf (Pagina 38)

CMP6-L, CMP10-L, CMP11-L, and CMP21-L Pyranometers

A-5

8. Attach the power cable to the CVF3 connector.

A.3.2 CVF4 Installation

To install, do the following:

1. Screw the CVF4 flat onto the mounting plate. Be sure to position the CVF4

so that the fan sticks out over the edge of the plate. See Figure A-7 for the

CVF4 mounting holes size and distances. The CVF4 is mounted with the

supplied washers and screws to the L31153 mount. Please note that 4 sets of

mounting hardware are included to mount the CVF4.

A-7 Mounted CVF4

2. Mount the radiometer in the CVF4 and level with its own levelling feet. The

radiometer mounting screws and shoulder washers are fitted (not secured).

If the CVF4 is mounted on a solar tracker, finish the alignment of

the traker first before securing the radiometer screws.

3. After all mounting screws have been secured, the CVF4 and radiometer

cables can be connected. The radiometer cable goes (down) through the slit in

the CVF4 base plate.

4. Put the CVF4 cover on; the 2 cover nuts can be fastened. Make sure the

cover is horizontal (check that there is equal space around the radiometer

dome) and that the 2 cover nuts are fastened hand tight.

Note

Ø 7 mm (2x)

1 2 ... 33 34 35 36 37 38 39 40 41 42

Sin comentarios

Campbell CVF4 Manual de instrucciones Pagina 38