Campbell TX312 Especificaciones descargar pdf (Pagina 85)

Appendix G. Extended ASCII Command Set

G-13

2,+348.5,-23.97,-55.7[CR][LF]

1,+3.24,-2.789,///,///[CR][LF]

5,-46,+86,+23.4[CR][LF]

2,+344.5,-28.88,-77.7[CR][LF]

1,+3.55,-2.733,///,///[CR][LF]

5,-24,+86,+25.4[CR][LF]

2,+645.5,-24.88,-77.7[CR][LF]

If FC=1 the format is the same except that each record is preceeded by a 24

hour time stamp with the format hh:mm:ss. The time stamp is always in 24

hour form and referenced to UTC.

This parameter is saved to non-volatile memory using the SAVE command and

is part of the configuration read back with the RCFG command.

G.4.7 Set SDI Sample Interval

Syntax:

SIN=hh:mm:ss

Access level: USER

TX312 State: Enabled/Disabled

Sets the sample interval for all SDI-12 sensors. If the interval is set to a value

less than the time required to perform all the SDI-12 measurements, the

measurements will be performed continuously. Setting the value to 00:00:00

effectively disables SDI-12 data collection.

Valid range is 00:00:00 to 23:59:59.

This parameter is saved to non-volatile memory using the SAVE command and

is part of the configuration read back with the RCFG command.

G.4.8 Set SDI Sample Interval Offset

Syntax:

SOF=hh:mm:ss

Access level: USER

TX312 State: Enabled/Disabled

Sets the sample interval offset for all SDI-12 sensors.

Valid range is 00:00:00 to 23:59:59.

This parameter is saved to non-volatile memory using the SAVE command and

is part of the configuration read back with the RCFG command.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 95 96

Sin comentarios

Campbell TX312 Especificaciones Pagina 85