Campbell CNR4 Manual de instrucciones descargar pdf (Pagina 14)

CNR4 Net Radiometer

5. Tighten the four screws on top of the mounting bracket to properly secure

the support arm so that it does not rotate (see FIGURE 4-2).

6. Perform the fine leveling using the two spring-loaded leveling screws—

one on the front and the other on the back of the bracket.

7. Route the sensor cable to the instrument enclosure.

8. Use the UV-resistant cable ties included with the tripod or tower to secure

the cable to the vertical pipe or crossarm and tripod/tower.

4.3 Short Cut Programming

The SCWin example provided here uses the thermistor to provide

the temperature correction.

Short Cut is an easy way to program your datalogger to measure the

pyranometer and assign datalogger wiring terminals. Use the following

procedure to get started.

1. Install Short Cut by clicking on the install file icon. Get the install file

from either www.campbellsci.com, the ResourceDVD, or find it in

installations of LoggerNet, PC200W, PC400, or RTDAQ software.

2. The Short Cut installation should place a Short Cut icon on the desktop of

your computer. To open Short Cut, click on this icon.

NOTE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 69 70

Sin comentarios

Campbell CNR4 Manual de instrucciones Pagina 14