Campbell CR800 Especificaciones descargar pdf (Pagina 321)

Appendix A. CR800 Status Table

A-7

13 Security can be changed via DeviceConfig, CR800KD, PBGraph,

StatusTable, and SetSecurity instruction. Shows -1 if security code has

not been given/deactivated.

14 When the SerialOpen instruction is used CommsConfig is loaded with the

format parameter of that instruction. Currently (11/2004), the only

formatting option available is 0 = No error checking. PakBus

communication can occur concurrently on the same port If the port was

previously opened (in the case of the CP UARTS) for PakBus, or if the

port is always opened ( CS-9pin, and RS232) for PakBus the code will be

15 The value show is the initial baud rate the CR800 will use. A negative

value will allow the CR800 to auto baud but will dictate at which baud

rate to begin

16 A list of up to 8 PB addresses for routers that can act as Central Routers.

See DeviceConfig for more information.

17 (1) 5000 mV range 250 uS integration,

(2) 2500 mV range 250 uS integration,

(3) 250 mV range 250 uS integration,

(4) 25 mV range 250 uS integration,

(5) 7.5 mV range 250 uS integration,

(6) 2.5 mV range 250 uS integration,

(7) 5000 mV range 1/60 Hz integration,

(8) 2500 mV range 1/60 Hz integration,

(9) 250 mV range 1/60 Hz integration,

(10) 25 mV range 1/60 Hz integration,

(11) 7.5 mV range 1/60 Hz integration,

(12) 2.5 mV range 1/60 Hz integration,

(13) 5000 mV range 1/50 Hz integration,

(14) 2500 mV range 1/50 Hz integration,

(15) 250 mV range 1/50 Hz integration,

(16) 25 mV range 1/50 Hz integration,

(17) 7.5 mV range 1/50 Hz integration,

(18) 2.5 mV range 1/50 Hz integration

1 2 ... 316 317 318 319 320 321 322 323 324

Sin comentarios

Campbell CR800 Especificaciones Pagina 321