Campbell SC932C 9-Pin Manual de instrucciones descargar pdf (Pagina 27)

WS-PRO2 Weather Station Manual

27176

Page 27 of 61

4.1.0 Enclosure, Datalogger, Power Supply

4.1.1 Battery Installation

Figure 16

The PS100 power switch should be in the “OFF” position. To install the

battery, remove the cover from the PS100 by sliding the latch up at one

end of the cover and sliding the cover down and out. Install the battery as

shown in Figure 16. Plug the battery lead into the connector labeled

“BATTERY – Internal 12V 7 Amp-Hour”. Put the cover back on the PS100

and latch it in place.

NOTE: Do not switch the power supply to “on” until AC or solar power has

been connected to the back of the enclosure.

The red charge light on the PS100 will glow when charging voltage is

present. The charge light is not affected by the switch. Switching on the

power supply without a charging voltage will run the battery down.

Figure 17 shows factory wiring between the PS100 and the enclosure.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 60 61

Sin comentarios

Campbell SC932C 9-Pin Manual de instrucciones Pagina 27