Campbell RAWS-P Manual

RAWS-P RemoteAutomated Weather StationRevision: 4/12Copyright © 2006-2012Campbell Scientific, Inc.

RAWS-P Remote Automated Weather Station 2. Getting Started Set up and test your station before field deployment. NOTE Keep this manual and the CR10

RAWS-P Remote Automated Weather Station CR1000KD packed in foam (may go here) FIGURE 2-1. Inside environmental enclosure (optional equipment shown)

RAWS-P Remote Automated Weather Station Use the CR1000KD Keyboard Display to see the “Public Variables” shown in Table 2-1. NOTE • Connect the CR100

RAWS-P Remote Automated Weather Station 3. Station Siting and Orientation 3.1 General Description Selecting an appropriate site for the RAWS is crit

RAWS-P Remote Automated Weather Station 3.6 Barometric Pressure The barometric pressure sensor is mounted to the back plate inside the RAWS environm

RAWS-P Remote Automated Weather Station 4.2 Rain Gage 4.2.1 General Description, Rain Gage (part #TE525-LQ) The Texas Electronics Rain Gage (part #

RAWS-P Remote Automated Weather Station 4.3.3 Troubleshooting, Pyranometer (part #CS300-LQ) Check the sensor cable. Disconnect the connector and use

RAWS-P Remote Automated Weather Station 4.4.2 2-D WindSonic 4.4.2.1 General Description, 2-D WindSonic (part #WindSonic-LQ) The Gill Instruments 2

RAWS-P Remote Automated Weather Station CS100 Barometric Pressure Sensor wires attached to CR1000 Wiring Panel CS100 Blue wire to CR1000 wiring pane

RAWS-P Remote Automated Weather Station Connector Panel “FM/FT” connector COLOR CODED BROWN Connector Pin A 107-LQ Temp. Signal to CR1000 4L Connec

RAWS-P Remote Automated Weather Station current flow from the battery to the solar panel, and 2) limits the source current to the battery. 5.1.3 Trou

RAWS-P Remote Automated Weather Station 5.2.2 Wiring, 12 V Charger/Regulator (part #CH100) The leads from the RAWS connector panel “BATT CHARGER/SOLA

RAWS-P Remote Automated Weather Station 5.3 Battery 5.3.1 General Description, Battery The RAWS battery is a rechargeable 12 volt battery. The bat

RAWS-P Remote Automated Weather Station The TX320 transmitter has two siting requirements for proper operation. The GOES antenna must have a clear vi

RAWS-P Remote Automated Weather Station 5.4.2 Wiring, GOES Transmitter (part #TX320) The GOES transmitter (part #TX320) is mounted inside the RAWS e

RAWS-P Remote Automated Weather Station FIGURE 5.5-1. Voice radio interface 5.5.2 Wiring, Voice Radio Interface (part #VSP3) The Voice Radio Interf

RAWS-P Remote Automated Weather Station 5.6 CR1000 Keyboard/Display 5.6.1 General Description, CR1000 Keyboard/Display (part #CR1000KD) The CR1000

RAWS-P Remote Automated Weather Station Consult the CR1000 manual for more information. NOTE 5.7 CR1000 Datalogger (part #CR1000) 5.7.1 General Des

RAWS-P Remote Automated Weather Station 5.7.2 Wiring, CR1000 Datalogger (part #CR1000) The CR1000 datalogger is mounted inside the RAWS environmental

RAWS-P Remote Automated Weather Station 7. Sensor and Equipment Maintenance 7.1 Sensor and Equipment Maintenance Proper maintenance of weather stati

Warranty “PRODUCTS MANUFACTURED BY CAMPBELL SCIENTIFIC, INC. are warranted by Campbell Scientific, Inc. (“Campbell”) to be free from defects in materi

RAWS-P Remote Automated Weather Station EPA, (1989): Quality Assurance Handbook for Air Pollution Measurement Systems, EPA Office of Research and Deve

RAWS-P Remote Automated Weather Station FIGURE 8.3-2. A declination angle East of True North (positive) is subtracted from 360 (0) degrees to find T

RAWS-P Remote Automated Weather Station FIGURE 8.3-4. USGS Web Calculator In the example above the declination for Logan, UT is 12º 24′ or 12.4º. A

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

Assistance Products may not be returned without prior authorization. The following contact information is for US and international customers residing

RAWS-P Table of Contents PDF viewers: These page numbers refer to the printed version of this document. Use the PDF reader bookmarks tab for links t

RAWS-P Table of Contents 4.6 Fuel Moisture and Fuel Temperature... 10 4.6.1 General Description, F

RAWS-P Table of Contents 8.3 RAWS Orientation ...22 8.3.1 Determining

RAWS-P Table of Contents iv

RAWS-P Remote Automated Weather Station 1. Introduction The RAWS environmental enclosure can be used for configuring a custom Remote Automated Weathe