Campbell CS475 Manual descargar pdf (Pagina 49)

Appendix B. SDI-12 Commands/Changing Settings

8. To change the SDI-12 address, enter the command aAb!; where a is the

current address from the above step and b is the new address. The sensor

will change its address and the datalogger will exit the SDI-12 Transparent

Mode.

9. Activate the SDI-12 Transparent Mode on Control Port 1 again by entering

*8#1 <enter>. Verify the new SDI-12 address by entering the ?! command.

The sensor will respond with the new address.

10. To exit the SDI-12 Transparent Mode, type in *0.

FIGURE B-5. SDI-12 transparent mode on CR10X-PB table-based

datalogger using control port 1 and changing SDI-12 address from

0 to 1

B-11

1 2 ... 44 45 46 47 48 49 50 51 52 53 54

Sin comentarios

Campbell CS475 Manual Pagina 49