Campbell CS475 Manual de usuario descargar pdf (Pagina 29)

User Manual

Minimum(1,Distance,FP2,0,0)

Average(1,Distance,FP2,False)

StdDev(1,Distance,FP2,False)

Maximum(1,Stage,FP2,0,0)

Minimum(1,Stage,FP2,0,0)

Average(1,Stage,FP2,False)

StdDev(1,Stage,FPs,False)

Sample (1,Error_Code,UINT2)

EndTable

'Read sensor every 60 seconds

BeginProg

Scan(60,sec,1,0)

'Code for SDI-12 measurements:

SDI12Recorder(CS475,1,0,”M!”,1,0)

'Call the data table:

CallTable(Hourly)

NextScan

EndProg

7.5.2 Edlog

Dataloggers that are programmed with Edlog include the CR500, CR510, CR10(X),

and CR23X. These dataloggers use Instruction 105 to read the sensor.

Instruction 105 allows data to be collected from the radar sensor; each sensor

requires a separate Instruction 105.

Instruction 105 has the following parameters:

Parameter 1 — Address. Valid addresses are 0 through 9; 65 through 90 (decimal

value for ASCII upper-case letters); and 97 through 122 (decimal values for ASCII

lower-case letters).

Parameter 2 — Command. Refer to the Edlog help for the command codes used

with this instruction.

Parameter 3 — Port. Enter the datalogger port in which the datalogger is connected.

Parameter 4 — Location. Enter the input location in which to store the results.

Parameter 5 — Multiplier

Parameter 6 — Offset

Edlog allocates only one of the input locations needed for this

instruction. Three input locations are required for this sensor. The

additional input locations must be inserted manually using the Input

Location Editor. For information on manually inserting input

locations, refer to Manually Inserting Input Locations in the Edlog

help.

NOTE

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Sin comentarios

Campbell CS475 Manual de usuario Pagina 29