
CRS451/CRS456 Submersible Water-Level Recording Sensor
20
Check battery condition by using a laptop and HydroSci software to view the
battery voltage (see Section 6.6, Battery Voltage Reading). The battery
replacement procedure is provided in Section 8.3, Battery Replacement.
Check all readings; adjust offsets if necessary.
Check recent data.
8.2 Every Two to Three Years or on a Rotating Schedule
Send the CRS451/CRS456 in for inspection and calibration.
8.3 Battery Replacement
Remove the set screws on the cap end of the CRS451.
Gently pull the end out of the housing.
Comentarios a estos manuales