Campbell AVW200 series Manual de usuario descargar pdf (Pagina 5)

Using Campbell AVW2xx Vibrating Wire Interfaces – MultiLogger Application Note #21 – Page 5 of 13

5. Once connected you will be shown the Deployment tab for the RF4xx.

The following are the main settings for configuring the RF4xx:

• Protocol (set to PakBus Aware)

• Hop Sequence

• Radio Address

• Power Mode

Note: Make sure the Hop Sequence, Net Address and Power Mode match the AVW2xx being

used with RF4xx.

See the RF4xx Operators Manual for information on other settings but for most deployments no other

settings need to be modified from the factory defaults.

Note: Contact Canary Systems for direction with more complicated configurations including

use of static PakBus route maps.

If settings are changed press the Apply button to update the RF4xx, otherwise press Disconnect. A

summary report will display, this can be saved as an XML file for updating other units or printed for

record keeping.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

Campbell AVW200 series Manual de usuario Pagina 5